Rod And Bearings

[riko666]

hi, someone on another site asked

does anyone know the torque specs on the rods and mains of a 4e block? are they the same as the 5e? thanks agian pimps.

can anyone help? lemme know

[riko666]

please anyone lemme know, it wud be a great help to me and especially the person asking for the info

[toyotasera.co.uk]

Cut and paste this into your reply.

**

4E-FTE Big End Bolt 400kgcm

4E-FTE Main Bearing cap 580kgcm

info from www.toyotasera.co.uk

**

[scandy001]

toyotasera, im the guy from the other site that riko was asking the ? for. thanks alot man i just have 2 other ?'s. do u know how to convert that into footlbs.? and do u know where i can get a new set of rod and main bearings. thanks toyotasera and riko

[Bakewell]

toyotasera.co.uk i am after a set of big end shells and a thrust plate for a 5e-fe. sorry to change the thread here. and i also need a head gasketb set if that posible

[scandy001]

bakewell, are u talking about the thrust washers that go on either side of the middle main cap. if so i can get u a set cheap, and if u need a head set wit a stock head gasket i can also get that fairly cheap too in U.S. currancy i don't know how to convert the currancies but i could find out.

[Bakewell]

yeah thats the one. ok here is a list for the moment:

head gasket set.

thrust washer.

big end shells.

i am sure i will need more as i am rebuilding my 5e-fe

[Boro Sera]

this is spooky.... I'm in the middle of rebuilding my 5E-FHE.

I'm using toyotasera.co.uk and my local Toyota dealer for the parts.

Rich

[riko666]

hey that would be 28.932ft/lbs and 41.9514ft/lbs respectively, and i think you can find rod and bearings at " importperformanceparts.com " too, hope that helped man