Fitting The Hks Turbo

[CAMSHAFT]

lads are ye know i got the turbo, but no instructions at all to fit it apart from biofotos, big thanks lads, the wireing is sorted. now we have done as much as we can do and now the probs start. from what we can see by looking at pics on different websites e.g TDi and WRC old car the oil goes in on top and comes out the bottom and back into the sump, so we have to drill the sump????. but there are 2 holes we don`t know what they are for one infront of the oil inlet under the elbow(pic1) the other behind (pic 2) lads we need help on this, so if ye can

PIC 1

PIC 2

the hole under the elbow in pic 1

Edited March 12, 2005 by CAMSHAFT

[biofotos]

Check you e-mail !!! :hokus-pokus:

Hope you have a fast connection !!!

[CAMSHAFT]

Check you e-mail !!! :hokus-pokus:

Hope you have a fast connection !!! 

←

a lad i can`t thank ya enough. SORTED

and again thanks.

:D :D :D

[admanirv]

hye allirght mate, hows this project coming on, be interesting to see outcome.

good luck

[RossP]

Oh yeh and if you can get it up on a rolling road when it's finished as i'm wanting to do this next summer and wouldn't mind seeing the improvements in power in torque etc etc

[CAMSHAFT]

Oh yeh and if you can get it up on a rolling road when it's finished as i'm wanting to do this next summer and wouldn't mind seeing the improvements in power in torque etc etc

←

should have it finished on wednesday evening all going well, i`ll get it on a rolling road over the next few weeks to see the differance and check if see is o.k

[biofotos]

If you keep the stock catalyst and the stock exhaust you will be dissapointed.. less than 90 ps...

[CAMSHAFT]

If you keep the stock catalyst and the stock exhaust you will be dissapointed.. less than 90 ps...

←

what did you change? the full system or cat back?

[biofotos]

The whole system. From downpipe, stainless steel 50 mm to the backbox. In the middle, Americat High flow catalyst. I had also to lengthen the wires of the second lambda sensor since I placed the catalyst where the stock middle - box (is this the right word ??) was.

After the turbine kit, the car was almost begging for a high flow exhaust system...

[CAMSHAFT]

The whole system. From downpipe, stainless steel 50 mm to the backbox. In the middle, Americat High flow catalyst. I had also to lengthen the wires of the second lambda sensor since I placed the catalyst where the stock middle - box (is this the right word ??) was.

After the turbine kit, the car was almost begging for a high flow exhaust system...

←

that will be the next job so and yea i understand where ya put the cat. just one more thing in the pic`s i posted above, even with the instructions (thanks again) i don`t know what if anything go in them, is yours the same, apart from that it`s finished going to drill the sump tomorrow and fit the oil return pipe and thats that and again thanks lad