Miracle411's Starlet Sportif V 2.0

[miracle411]

Glanza Lights, Apexi Induction Kit, Euro Sport Custom back-box 4" Round and Angled Tip. Oh and picture happy me. HAHA! Sorry you 56k bashers, you need to upgrade. Peace.

[markweatherill]

What's holding the air filter up? Doesn't it wave around like that..?

You can safely lose the odd shaped 'thing' attached to the induction hose, as far as I can tell it doesn't do anything - unless you know different.

The hole it's plugging is handy for the air temp. sensor to go into, if your engine is similar to mine which it appears to be.

[Captain Starlet]

if you unplug that from the air hose then nothing is feeding the breather hole for you engine...aka any ***** goes in,if your removing it (which is pointless) you would need to add a breather filter of sumkind

i think :S sure sum1 will say for definate

[nrgizerbunny]

i *think* it equalises the air pressure in the head. if you don't then the engine will start sucking in oil. could be for the servo assist on the brakes - but i have never checked to see where this is. its usually on the the engine side of the throttle valve hence unlikely to be this.

[miracle411]

What's holding the air filter up? Doesn't it wave around like that..?

You can safely lose the odd shaped 'thing' attached to the induction hose, as far as I can tell it doesn't do anything - unless you know different.

The hole it's plugging is handy for the air temp. sensor to go into, if your engine is similar to mine which it appears to be.

←

nothing is holding it up, the piping is pretty strong it doesn't move around hardly at all, as for the air temp sensor i just mounted it behind the filter. runs fine just the same, most likely better thanks to the apexi, so far so good.

[Humayun]

I think the plast thing attached to the intake pipe is a resonator chamber to silence intake noise.

I took mine off and sealed the hole by inserting a mineral water bottle cap which i then clamped with a jubilee clip.

I cut a hole in the bottle cap for the air temp sensor and sealed it in, it seemed to do the job very well.

Jus thgt id let u guyshow i went bout it

[miracle411]

I think the plast thing attached to the intake pipe is a resonator chamber to silence intake noise.

I took mine off and sealed the hole by inserting a mineral water bottle cap which i then clamped with a jubilee clip.

I cut a hole in the bottle cap for the air temp sensor and sealed it in, it seemed to do the job very well.

Jus thgt id let u guyshow i went bout it

←

I thats a good place to put it dude, just sorted it out now, thanks a lot.