How To Connect Up?

[Diavlo]

Ok, seeing as how these things have been sitting around in my garage for about two weeks, does someone who has installed these know how to wire them up?

Please can you give me a brief run through of what you did, and more specifically, which wire goes where.

Thanks...

[Chyownster]

Basically i took out all the wires and put some chunkier wire in makine sure that all the earth connections were in the same(make sure u note which wires u pull off!!)

Then worked out that the reversing light and the fog light needed to be modified to fit standard bulb holders in so i bored into the light. U wont neeed to do this if u have a T Sport or if the lights are Euro spec. i was just determined to make my Jap versions fit!!!

Then make a note which pin in the plug from the OE light does what. get somone to press the bbrake lights, etc and use a light tester to help u.

Wire the positive connections on each of the bulbs to the light with some small spade terminals and put the right wire in the corresponding plug.

If this doesnt make any sense then i will totally understand lol

[yaristpot]

Diavlo

Where you based??

[vmail]

Basically i took out all the wires and put some chunkier wire in makine sure that all the earth connections were in the same(make sure u note which wires u pull off!!)

Then worked out that the reversing light and the fog light needed to be modified to fit standard bulb holders in so i bored into the light.  U wont neeed to do this if u have a T Sport or if the lights are Euro spec.  i was just determined to make my Jap versions fit!!!

Then make a note which pin in the plug from the OE light does what.  get somone to press the bbrake lights, etc and use a light tester to help u. 

Wire the positive connections on each of the bulbs to the light with some small spade terminals and put the right wire in the corresponding plug.

If this doesnt make any sense then i will totally understand lol

so uve got the jap version, me too, again, how did you make the bulb holes bigger to fit the standad bulb holder? maybe i could drop into bolton and you can show me how its done

wiring is the easy bit

[vmail]

is the small red 1 the fog, and the big red 1 for brake/driving???

[vmail]

oh wait the small red one also has an extra wires, is that for the driving light aswell

[Chyownster]

I used a Dremil type thing and cut into the light. It was a pain cos some of the cut out fell into the light so i was shaking them out for ages!! The inner ones are the fog and reverse, by law right hand side has to be Fog and the other will be Reverse. Or u could use both of the red ones that arent used for Stop/tail and use them as Fog and use bothe the ones on the side as Reverse.

[vmail]

impossible unless you cut the bulb holdeer aswell, just managed to do the indicator with a knife, with the other 2 i will need to cut the bulb holder

[Chyownster]

Nope didnt cut the holder

[Ryan1985]

Why don't u just get euro spec 1's like me? No problems!!!

[Ryan1985]

This is them

[Diavlo]

The Euro spec ones no longer are manufacturer... Ryan you got the last of them from Illusion... I ordered mine and they were Jappo after asking for Euro ones....

Turns out Ultra only make the jap ones now...

I fitted them fine tho... I'll post some pics of my Yaris soon...